Setting up your Humax Freesat media player to use My Private Network’s MyTelly service should take just a few minutes by following the steps below. Please note that your Humax Freesat needs to be connected to the Internet and able to browse the web before moving on with the instructions below. You do not need to be connected to our VPN for MyTelly to work, kindly disconnect from the VPN if you have it turned on.

Whilst the Humax Freesat supports a web browser, we recommend that you use a computer to register your IP Address on our network.

Not yet registered? It’s quick and easy, give our 3-Day Free Trial a try now!

Check MyTelly DNS Settings

 
Login to our website, www.my-private-network.co.uk from your computer browser and you should be redirected to the My Subscription page.
 
Select the MyTelly tab on the left hand corner of the screen and click on Setup.
 
Check MyTelly Settings
 
Take note of the DNS server addresses that appears on your screen, you’ll need it during the setup later.
 
Note: The DNS addresses shown in the images here are just examples. Please follow the ones displayed on your own screen.


Register IP Address for MyTelly

 
Scroll down and click on Register This Address. This will register your IP address and also test your DNS setup to indicate whether you have configured the DNS settings correctly.
 
Check MyTelly Settings
 
Please note that in this instance, since you are only changing the DNS settings on your Humax Freesat later and not on your computer, the authentication page will return the following error:
 
Confirm MyTelly Settings
 
Please do not worry about this message as our servers have already registered your IP address as per the image above.
 
To learn more about the MyTelly errors, please refer to our article below:
MyTelly errors – Your DNS setting is not configured correctly.
 
Note: You will not have to do it again unless your IP address changes. Also, any device on the same network will be able to use the MyTelly service as long as you’ve set our DNS on their device’s settings.


Setup MyTelly on your Humax Freesay

 
1) Press MENU on your Freesat remote control.
 
2) Navigate to SYSTEM.
 
3) Choose NETWORK.
 
4) Press CONFIGURE NETWORK.
 
5) Choose CONFIGURE IP.
 
6) Choose MANUAL.
 
7) Navigate down to DNS ADDRESS and enter the DNS server addresses that appeared in Step 1. Do not alter any of the other settings.
 
8) Press Apply, then reboot the Freesat receiver.
 
If your IP address was registered successfully as shown in Step 2 and the DNS has been set up correctly on your Humax Freesat, you should now be able to access the relevant Media Apps on your Humax Freesat.
 
Go ahead and access any TV content providers that we support!


Any Problems?

 
Unfortunately it doesn’t always go to plan!
 
If you have any problems or can’t get MyTelly to work, please email us at support@my-private-network.co.uk. We’ll get back to you as soon as possible and try to help.